Torsional Strength
|
 |
ISO No.
Ø (mm) |
ISO No.8
4.2 |
ISO No.10
4.8 |
ISO No.12
5.5 |
ISO No.14
6.3 |
| Inch - lbs |
42.5 |
84 |
130 |
150 |
| Nm |
4.8 |
7.0 |
10.5 |
13.8 |
Pull-out Strength
|
 |
Screw Style¹ |
Drill-Point
No. 1 |
Steel Thickness
mm |
0.63 |
1.00 |
1.25 |
| LBS |
235 |
360 |
575 |
| kN |
1.05 |
1.60 |
2.56 |
| Screw Style² |
Drill-Point No. 2 |
Steel Thickness
mm |
1.0 |
1.5 |
2.0 |
2.5 |
3.0 |
| LBS |
255 |
455 |
685 |
935 |
1185 |
| kN |
1.14 |
2.02 |
3.04 |
4.15 |
5.27 |
| Screw Style² |
Drill-Point No. 5 |
Steel Thickness
mm |
5.0 |
6.0 |
| LBS |
2140 |
2860 |
| N |
9.51 |
12.72* |
|
|
Pull-over
values
(With 16mm washer)
|
 |
Steel Thickness
mm |
lbs |
kn |
| 0.63 |
1085 |
4.85 |
| 0.75 |
1330 |
5.95 |
| 1.00 |
1930 |
8.62 |
| 1.25 |
2195 |
9.79 |
Shear Strength
|
 |
ISO No.
Ø (mm) |
ISO
No.8
4.2 |
ISO
No.10
4.8 |
ISO
No.12
5.5 |
ISO
No.12
6.3 |
| lbs |
940 |
1245 |
1640 |
2410 |
| kN |
4.17 |
5.53 |
7.28 |
10.71 |
Tensile Strength
|
 |
ISO No.
Ø (mm) |
ISO
No.8
4.2 |
ISO
No.10
4.8 |
ISO
No.12
5.5 |
ISO
No.14
6.3 |
| lbs |
1440 |
1780 |
2340 |
3440 |
| kN |
6.4 |
7.9 |
10.4 |
15.3 |
Recommended Drill Speed
|
| Recommended drill speed
for screw guns under axial load |
| Screw Diameter |
Minimum |
Maximum |
up to Ø 4.8
up to Ø 5.5
up to Ø 6.3 |
1800
1000
1000 |
2200
1600
1600 |
* Over 6mm limited due to Tensile Strength.
1 Values refer to diameter 4.8mm.
2 Values refer to diameter 5.5mm.
Test results have been obtained in conjunction with St-37 steel by an independent test laboratory.
|
